KLINGERQuantum

  • HNBR Binder
  • Synthetic Fiber
  • High Performance with Outstanding High-Temperature Properties
  • Maintains Flexibility at High Temperatures
  • Suitable with a Broad Range of Media
  • Simple Handling and Processing
  • FDA Compliant when installed ubranded

Typical values refer to 2.0 mm material unless otherwise specified.

See graphs for temperature & pressure limits

Compressibility ASTM F36J

10%

Recovery ASTM F36J

60%

Stress Relaxation DIN 52913

50 MPa, 16 h/300°C

50 MPa, 16 h/175°C

 

28 MPa

32 MPa

Stress Relaxation BS 7531 1.5 mm

40 MPa 16 h/300°C

 

27 MPa

KLINGER Cold/Hot Compression 50 MPa

Thickness Decrease 23°C

Thickness Decrease 300°C

Thickness Decrease 400°C

 

10%

14%

20%

Tightness DIN 28090-2

0.02 mg/s x m

Thickness Increase After Fluid Immersion ASTM F146

Oil IRM 903: 5 h/150°C

Fuel B: 5 h/23°C

 

3%

5%

Density DIN 28090-2

1.7 g/cm³

ASTM F104 Line Call Out

F712122B3E22M5

Pressure & Temperature Graphs

Material Thickness: 2.0 mm

The pressure/temperature graphs shown are the most current method of determining the suitability of a gasket material in a known environment. Use the pressure and temperature graphs to select the most suitable material for your application.

  • 1. In area one, the gasket material is suitable using common installation practices subject to chemical compatibility.
  • 2. In area two, appropriate measures are necessary for installation of the gasket to ensure maximum performance. Please call or refer to the KLINGER® expert software system for assistance.
  • 3. In area three, do not install gaskets in these applications without first referring to the KLINGER® expert software system or contacting Thermoseal Inc.'s technical support service

These graphs were developed from testing Klinger materials. Do not use them for competitors' materials since non-asbestos gasketing materials do not have service equivalents.

Use: The limitations of use, as shown in the graphs, are for guidance only, and are based on 1/16" thick material. The limitations of use decrease significantly as gasket thickness increases. Do not use a thicker gasket material or "double gaskets" to solve a gasket problem without first consulting the manufacturer. The ability of a gasket material to make and maintain a seal depends not only on the quality of the gasket material, but also on medium being sealed, the flange design, the amount of pressure applied to the gasket by the bolts and how the gasket is assembled into the flanges and tightened. Thermoseal engineers can advise on gasket selection and installation based on specified operating conditions. If you are in any doubt, fax us at 937.498.4911 or phone us at 937.498.2222.

For Additional Information Call Toll Free 1.800.990.7325 or email This email address is being protected from spambots. You need JavaScript enabled to view it.