Skip to main content

KLINGERSIL® C-4430

Outstanding stress relaxation and resistance to hot water and steam

 
KLINGERSIL® C-4430 is a universal gasket material, suitable for a wide range of applications. C-4430 is resistant to water and steam at higher temperatures as well as oils, gases, salt solutions, fuels, alcohols, moderate organic and inorganic acids, hydrocarbons, lubricants, and refrigerants.

The material is manufactured with a combination of aramid fiber and fiberglass reinforced with a nitrile binder.

Purchase Here

Klingersil C-4430

 

Typical Values Refer to 1/16" Thick Material Unless Noted

Creep relaxation ASTM F38B (1/32") 20 %
Sealability ASTM F37A (1/32") < 0.5 ml/hr
Gas Permeability DIN 3535/6 < 0.5 ml/min
Compressibility ASTM F36J 6 - 14 %
Recovery ASTM F36J 50 % minimum
KLINGER Hot Compression Test
Thickness Decrease 73°F (23°C)
Thickness Decrease 572°F (23°C)

12 % initial
11 % additional
Weight increase ASTM F146 after immersion in
Fuel B, 5h/73°F (23°C)

10 % maximum
Thickness Increase ASTM F146 after immersion in
ASTM Oil IRM 901, 5h/300°F (149°C)
ASTM Oil IRM 903, 5h/300°F (149°C)
ASTM Fuel A, 5h/73°F (23°C)
ASTM Fuel B, 5h/73°F (23°C)

0 - 5 %
0 - 3 %
0 - 5 %
0 - 5 %
Dielectric Strength ASTM D149-95a 16 kV/mm
Density ASTM F1315 96 lb/ft ³ (1.55 g/cc ³)
Leachable Chloride Content FSA Method 150 ppm
ASTM F104 Line Call Out F712132B3E11K6M5
Color Green/white

 

The pressure/temperature graphs shown are the most current method of determining the suitability of a gasket material in a known environment. However, chemical compatibility must also be considered.
 
pT diagram for thickness 1/16":
 
LIQUIDS
C-4430 Liquid
GASES & STEAM
C-4430 Gasses and Steam
In area 1 the gasket material is suitable using common installment practices subject to chemical compatibility

In area 2 appropriate measures are necessary for installation of the gasket to ensure maximum performance. Please call or refer to KLINGERexpert for assistance.

In area 3 do not install gaskets in these applications without first referring to KLINGERexpert or contacting Thermoseal Inc.'s technical support service.
 
The ability of a gasket to make and maintain a seal depends not only on the style and quality of the gasket material, but also on medium being sealed, the flange design, the amount of pressure applied to the gasket by the bolts and how the gasket is assembled onto the flanges and tightened. These factors are beyond the manufacturer's control. Please take note of our installation manual in TECHNICAL RESOURCES.